holes. . Now sand all of the sides until there is no overhang between the three layers of wood. . First measure the diameter of each of the sockets. . Step 2: Design the Main Body. Step 9: Sand, Seal, Sand, and Seal Some More. The magnetic strips will be embedded in the top of the base (so that they will be flush with the socket holes in the main body). . In my case it took 4 passes at 100 power and 30 speed. The magnetic strips are 1/2" wide, so make the rectangles.54" wide so they won't have an interference fit. . Finally, draw a rectangle around the entire group of text that is the length of the main body. .
The photo shows all three pieces rough sanded (I forgot to take a picture of the middle section before engraving, but I did sand it first). The magnetic strips are sherwin williams coupon 15 not very strong, but will help keep the sockets from accidentally popping out when bumped or jostled. . Step 6: Sand Everything, make a first pass at sanding all of the pieces. . Now apply a coat of spray polyurethane, let it dry, sand again, spray again, and repeat until you are happy with the finish. Use a different color such as blue so that it will neither be engraved nor cut.
You can determine the center to center distance by adding the diameter of the two adjacent circles, dividing that by two, then adding.1". . Although the walnut is much thinner than the poplar, it is harder to cut thus the same laser settings. .